![]() ![]() How to Use Ford VCM II Scan tool to Read and Clear Mondeo DTCs? When the icon shown in the figure below appears, the VCM update is complete and it can be used normally. When the upgrade completed, the following prompt interface will appear, and the VCM II will automatically restart,wait until you hear the “beep”. When you see the following image, it means you enter the recovery mode.Īfter clicking on the “Recover” button, the program will switch to the VCMII Update interface.Ĭlick on “Start Update” to start the firmware update, and the following image will appear “Do not unplug the VCM II from the PC or remove power from the VCM II during the update process.”Īfter clicking on “OK”, the following image will appear to start writing the new version of firmware. Run BoschVCI Software(Ford-VCM-II)VCI Manger(Ford-VCM-II). It appears everything is working as it should now.Ĭonnect the USB cable to the VCM2 device and hold the (ReSet) button shown as below.Ĭonnect the other end of the USB to a computer with IDS V86 installed, and then release the ReSet button until you hear a beep sound. Problem:Finished installing the IDS v86 software but now it won’t recognize the VCM2.įeedback: I was able to update with vci. If i can get all of them to work with my AVDI, then bingo.Recently, CnAutotool has received some question about Ford VCM2 firmware downgrade, Following is a detailed description and solution of the problem. I have been having running battle with using my DIS v57 with my AVDI, I have HDS hardware and software too, i have Ford IDS, just got it and its installed but never tried it out yet with Jag IDS. ![]() M8, you might as well start being the Man of the Month of January if you can sort this VMWARE thing out for us all.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |